Community
Ask A Question
Subscribe
You’re not receiving notifications from this thread.
How to configure the splitter
Created by Lienhard Menzi • 9 months ago
General
Lienhard Menzi
On Aug 20, 2023
The Splitter asks for #input bit and then for #outputbits, but it shows me alway one single output. I can't even configure the outputbits in the properties. Has anyone a solution.
@Focaspeed
On Aug 22, 2023
I understand you perfectly too. Explaining it in writing is a bit difficult for me and secondly I might cause confusion... so I'll leave you here the link to the CircuitVerse youtube video where they explain well how to do it. This is the link: https://www.youtube.com/watch?v=eeCFOYr2fFI&list=PLuIwo5F99zKa_-ngPfYX7HV9louNrRTAh&index=7 Minute 2:57 ;)
